The reviews are automatic translation.
For maintenance of equipment
On 2018-02-07 20:41:30
Because there is a little wall thickness, it may not enter depending on the place.
However, with just this, workability has improved much.
It is easy to understand into the handle if possible and there is no mention of the size of the nut.
For PC maintenance
On 2017-02-18 22:47:30
I stuck a little and chose a thin one. Working efficiency has improved dramatically. I am satisfied.
Maintenance of the motorcycle
On 2016-08-03 21:25:37
It is cheap and there is, it is very convenient.
On 2016-04-02 15:16:17
Because the embroidery is thin, the force does not need the sun
Assembling of electronic equipment
On 2016-03-02 15:49:06
The shaft was too long and it was difficult to handle.
On 2014-05-17 06:54:50
Especially it is used especially for tightening work of small hand nut and returning work.
Tightening of Jubilee Band
On 2013-11-14 13:31:36
I think that it would have been satisfactory if it were to install parts on the board. When using it for tightening the Jubilee band, I felt that a slightly thicker grip was better to apply the torque.
When interior decoration and fender temporary adjustment etc.
On 2013-09-04 22:11:16
Grip place, feeling slippery · · · I use it with red grip, number 80 and slip prevention
Loosen and tighten the nut
On 2013-07-22 21:32:19
I ordered and stocked it as a spare item, so I did not use it for more than a year. (I can not return it?) I did not notice any abnormalities. As I saw nuts not turning, it was only with pipes around 10 φ with no mountain. I wonder how to sell the nut drivers that nuts will not stop in peace.
On 2011-11-02 10:51:51
The one that arrived first was bent in the grip and stuck, and it could not be used. The item after exchange is not straight. It is the lowest item of doubt even whether it is inspecting. It is better not to buy it.