Measuring Tools
After disassembling and servicing the car, the parts and body must be assembled. A device that checks whether the assembled parts are normal is a measuring instrument. Although it is used sequentially during assembly, it is checked with measuring equipment whether it is assembled as designed. The joint part of the car is tightened with bolts, etc., but the measurement tool to check this tightening force is a torque wrench. Cars also have complex electrical systems and built-in microcomputers. The measuring instruments for this are multimeters and code readers. The current and voltage can be measured to diagnose the cause of abnormal car operation. Vernier calipers for measuring dimensions and tachometers for measuring rotational force are measuring instruments stipulated by the law for certification by maintenance shops.
Other Related Pages
JTC Sound scopeIt is possible to switch by sensor while driving and accurately detect the location of abnormal noise.RoHS directive (corresponding to 10 substances) Correspondencefrom S$459.90Min. 2 days- JTC Compression test adapterRoHS directive (corresponding to 10 substances) Correspondencefrom S$199.90Min. 7 days
- MonotaRO Electroscope tester with LED + buzzer DC6-24V onlyYou can check the energization not only with light but also with buzzer sound. The LED light is also distinguished by red (-) and green (+), and the polarity can be confirmed. Electroscope work such as checking energization and polarity * Do not use for anything other than its intended purpose. *... Read MoreMaterial (Cap) PP (both front and rear) Electricity Detection Range (V) (DC)6～24 Material (Body) ABS (blue part), AS (transparent part) Material (Needle) Iron (nickel plating)
- MonotaRO Voltage detection tester DC6 to 24V onlyWiring cord voltage detection is possible. If the power is on, the incandescent light built into the handle will glow. * Do not use for anything other than its intended purpose.Material (Grip) AS material Electricity Detection Range (V) (DC)6～24
- MonotaRO Sound scope with sound collectorIt is a stethoscope for automobiles that can hear various abnormal noises such as valves, bearings, and water pumps in engines and missions. In addition, it is equipped with a sound collector so that you can hear fine sounds. Since it is a 3mm shaft, it is effective even in narrow spaces. If you ... Read MoreIncluded Accessories Sound collector Shaft Diameter (Φmm) 3
- MonotaRO Compression testerYou can easily measure the cylinder compression of a gasoline engine. Comes with 2 types of aluminum tubes (straight and curved types), allowing you to measure various engines. Various adapters for standard cylinders are included. Equipped with a self-locking mechanism on the rubber hose. No need... Read MoreMeasuring Range (kPa) 0～2100 Adapter size M10×1.0・M12×1.25・M14×1.25・M18×1.5
- ANEX Buzzer & LED auto testerAdopting a long-life LED, you can know the presence or absence of voltage and polarity judgment of the car by sound and light.Mass (g) 43 Tip Needle type DC Voltage (V) 6～24
- Amon Industry Voltage Detection TesterEasy-to-use basic type Check energization with LED lightAllowable Voltage Range For DC6V ~ 24V
- MonotaRO Code readerThe code reader is a DTC (Diagnostic Trouble Cord) reader that can be easily handled simply by inserting it into the OBDII standard socket (connection port 16 pin), and reads and displays the P code (power train system) of the engine transmission. It is a fault diagnosis machine for automobiles t... Read MoreIncluded Accessories Exclusive drawstring bag Display 2 inches Operating Ambient Temperature (℃) 0～50 Rated Operating Voltage (V) DC12 Language Display English
- MonotaRO Universal Pitch GaugeFour types of pitch gauges can measure various millimeter / inch size screw pitches and bolt diameters. For measuring screw pitch and bolt diameter * Do not use for any other purpose.Material Aluminum
- JTC Plastic gaugeFor metal clearance measurementRoHS directive (corresponding to 10 substances) Correspondence
- Amon Industry Voltage detection testerStylish and sharp form with particular attention to design You can check the energization of DC6V to DC24V with the LED light and buzzer sound. Polarity can be confirmed with 2-color LED (red / green)LED One 2-color LED (red / green) Usable voltage (V) DC6～DC24
- MonotaRO Cordless circuit testerWhen the needle part at the tip of the tester touches the target object, the rear LED light will light up and a buzzer will sound if the tester is energized. A cordless cord tester that can detect the voltage of a DC circuit without using a ground wire. When a positive voltage is detected, the bu... Read MoreIncluded Accessories A23 dry cell (12V) x 2 Measuring Range DC3～28V Mass (g) 50 Suitable Battery AAA battery x 2
- MonotaRO Torque Angle GaugePlace the L-shaped rod against the surrounding object to fix the main body, and turn it to the specified angle. After tightening with a torque wrench, when tightening further depending on the angle. * Do not use for anything other than its intended purpose. * Check that the snap ring is not loose... Read MoreMass (g) 160 (including wrench) Angle Measuring Range (°) 360 Minimum Scale 2° Gauge diameter (Φmm) 68
- Mother Tool Digital MultimetersMulti-function 4000 count indicator board Japanese support makes range setting easy to understand.Included Accessories Instruction Manual / Battery / Test Lead Mass (g) About 300 Power Supply 9V(006P)×1 AC Voltage (V) 400m/4/40/400/750 Frequency 9.999Hz～10MHz DC Voltage 400mV/4V/40V/400V/1000V DC Vurrent 400μA/4000μA/40mA/400mA/4A/10A Resistance 400Ω/4KΩ/40KΩ/400KΩ/4MΩ/40MΩ AC Current 400μA/4000μA/40mA/400mA/4A/10A Duty Ratio 0.1%～99.9% Capacitance 40nF/400nF/4μF/40μF/400μF/4000μF
- JTC Code readerNo complicated settings required! Ready to use! No version upgrade required! Maintenance fee 0 yen! For reading and erasing P-codes. * Only for light car to ordinary car enginesRoHS directive (corresponding to 10 substances) Correspondence
- SIGNET Mechanic test scopeA scope that can clearly detect injector operating noise and noise from the engine and transmission. The aluminum needle with a total length of 280 mm makes it easy to access narrow and hard-to-reach places and catch fine noise clearly. If you replace the needle with the attached rubber trumpet, ... Read More
- Mother Tool Pocket Digital MultimeterMulti-function type with 6000 count bar graphMass (g) About 125 Power Supply CR2023 x 1 (Built-in body) AC Voltage (V) 6/60/600 Frequency 1Hz～10MHz DC Voltage 600mV/6V/60V/600V DC Vurrent 60mA/600mA Resistance 600Ω/6KΩ/60KΩ/600KΩ/6MΩ/60MΩ AC Current 60mA/600mA Capacitance 40nF/400nF/4μF/40μF/400μF/4000μF
- SIGNET Brake fluid testerGood or bad is judged by the amount of water in the brake oil. Since it is composed of 5 LEDs, you can grasp the status in detail. * Uses AAA (1.5V) batteries (sold separately)
- SUNFLAG (SHINKI MFG) Auto Tester Pencil Tip TypeUses 6V to 24V dual-purpose balls, applicable to small to large vehicles. It can be used as a tester for disconnection tests and timing lights of internal heat engines such as automobiles and motorcycles, tail lights, turn signals, fuses, sockets, etc. For detecting the power of car batteries.Mass (g) 36 Voltage (V) 6～24 RoHS directive (corresponding to 10 substances) Correspondence
- NPA (Toyo Tech) Handy vacuum pumpA device that manually generates vacuum pressure. Since it can be decompressed to any pressure, it is an indispensable device for maintenance of equipment operated by vacuum pressure.Included Accessories Hose (500mm) Mass (g) About 800 Diameter (Φmm) (Meter) 50 Maximum Scale -100kPa (about 75cmHg) Minimum Scale (kPa) 2from S$339.90Min. 2 days
- MonotaRO Camber caster gaugeA gauge can be attached to the side of the wheel to read the position of air bubbles on the top of the main unit. * Do not knock it down or drop it. * Do not shake or vibrate.Measuring Accuracy (°) 0.5
- JTC Compression tester full setFor gasoline vehiclesMeasuring Range (kPa) 0～2100 RoHS directive (corresponding to 10 substances) Correspondence Adapter size M10×1.0・M12×1.25・M14×1.25・M18×1.5
- JTC Digital Depth GaugeLiquid crystal displayUnit of Measurement 0.01mm RoHS directive (corresponding to 10 substances) Correspondence Operating Temperature Range (℃) 0～40from S$53.99Min. 2 days
- JTC Brake gauge setYou can easily measure the remaining amount of brake pads. Very convenient for vehicle inspection!RoHS directive (corresponding to 10 substances) Correspondencefrom S$47.99Min. 2 days
- JTC Brake oil testerGood or bad is judged by the amount of water in the brake oil. * Cannot be used for DOT5.Suitable for DOT3、4 RoHS directive (corresponding to 10 substances) Correspondencefrom S$78.99Min. 2 days
- JTC Mighty bag* Only negative pressure cannot be pressurized.Material (Main Unit) Aluminum die-cast Measuring Range (kPa) (Load) 0-100 RoHS directive (corresponding to 10 substances) Correspondencefrom S$339.90Min. 2 days
- NPA (Toyo Tech) Compression tester for gasoline engineSince it is screwed into the spark plug hole with a hose adapter and fixed, it can be measured by one person. In addition, screwing is only by hand tightening and no tools are required, and the tester body can be attached and detached quickly and easily with a coupler type. The total length of th... Read MoreIncluded Accessories 1 spare O-ring for each of 10, 12, 14 mm Mass (g) About 1850 Diameter (Φmm) (Meter) 60 Minimum Scale (MPa) 0.1
- JTC Sound scopeFor listening to abnormal noise from the engine, etc.RoHS directive (corresponding to 10 substances) Correspondencefrom S$47.99Min. 2 days
- MonotaRO Actuator testerIt is a tester that the LED reacts with a light emission or a buzzer sound when it detects a magnetic force or an electromagnetic field. A simple operation check can be performed by simply touching the tip of this product to the part you want to inspect. For operation inspection of injectors, ign... Read MoreSuitable Battery AA type × 2 (sold separately)
- JTC Oil pressure testerUsed for measuring engine oil pressure.RoHS directive (corresponding to 10 substances) Correspondence Adapter size M8×1.0・M10×1.0・1/4×18・1/8×27・3/8×18
- Mother Tool AC / DC Digital Clamp MeterLightweight and compact with auto range with tester function Measures DC / AC current 400A and DC / AC voltage 450V With data hold function With auto zero / adjust function With continuity buzzerMass (g) About 150 Power Supply UM-4(1.5V)×2 Maximum Measuring Conductor Diameter (Φmm) 28from S$259.90Min. 2 days
- JTC With sound scope sound collectorIt is this sound scope that reliably catches mechanical noise, which is a danger signal from the engine and transmission. Since it uses an aluminum tip needle of about 275 mm, it can work even in narrow places and pick up noise clearly. If you use the included rubber trumpet, you can also check f... Read MoreRoHS directive (corresponding to 10 substances) Correspondence
- Sanko Seiki Unauthorized fuel discriminator Digital light oil discriminator (Checkerman)Distinguish between light oil, kerosene, and heavy fuel oil A. Illegal fuel is blinking. Easy-to-read 5-digit display. With a lens cover to prevent malfunctions outdoors. Just drop one or two drops of oil. After reading, the abnormal value flashes. Since the numerical value is temperature-correct... Read MoreMeasuring Range 1.33330～1.5318 Mass (g) 130 (without batteries) Function Auto power off Digit Number of Display 5 Suitable Battery 1 x AAA battery Operating Ambient Temperature (℃) 5～40from S$799.90Min. 2 days
- NPA (Toyo Tech) Compression tester for gasoline engine Optional adapterSuitable for G-1C
- NPA (Toyo Tech) Compression tester for diesel engineMeasure the compression by connecting the attached adapter compatible with the diesel engine. DS-9 is for midsize cars (for nozzle holders), DJ-9H is for glow plugsDiameter (Φmm) (Meter) 75 Minimum Scale (MPa) 0.2from S$999.00Min. 2 days
- Mother Tool Brake fluid testerA brake fluid tester that determines the deterioration of fluid fluid in three stages.Mass (g) Approx. 220 (including batteries)from S$159.90Min. 2 days
- JTC Adapter 10mm ・ 12mmRoHS directive (corresponding to 10 substances) Correspondence
- OTC Brake pad gaugeIt is a convenient tool that can measure the thickness of brake pads without removing the foil and parts. (In rare cases, there are some models that require foil removal.) * Calibration method: The factory default setting is such that the scale is at the 4 mm position when the probe tip is locked... Read More
- JTC Brake rotor & tire depth gaugeThe thickness of the brake rotor can be measured.RoHS directive (corresponding to 10 substances) Correspondencefrom S$79.99Min. 7 days
