Wheel Truing Stands

A set of dial gauge and bracket that can be attached to TS-2 / TS-2.2. It is possible to check the vertical and horizontal runouts in units of 0.01 mm. The tip of the dial gauge has a special shape for each bicycle wheel.

By attaching to the TS-2 / 2.2 / 2.2P arm, it is an attachment that can be used for through axles and wide hubs up to 200 mm. Even with 29-inch wheels, you can perform wheel truing work with the tires attached. It is a quick release type and can be easily installed. A slot for fixing the wheels o... Read More

With tilt function for TS-4.2 The angle of the base can be adjusted by about 20 degrees. With spoke wrench storage pocket and parts tray. * Cannot be used with TS-4.

A simple wheel truing stand that attaches to the repair stand. Secure the wheel with a quick release lever or hub nut and check for wheel runout.

MT (Advanced Mag Turbo) … Pedal feeling ideal for hill climb practice The world's strongest neodymium (Nd) magnet is used for seasoning that emphasizes the feeling on slopes rather than the reproducibility of running on flat ground. A flywheel with a steer step design that produces an inerti... Read More

A hybrid roller created to improve the feeling of actual driving and pedaling skills. Two rollers with high rotational accuracy give the best results for training. Self-weight type that does not require roller pressure adjustment. (A method in which the weight of the rider and the bicycle is dire... Read More

Attachment for HTR-1 (head tube reamer) By replacing the face cutter with # 687, only reaming work is possible.

A dial gauge that can be used by attaching it to the DT-3 more accurately. The dial gauge quantifies the measurement of slight distortion.

A wheel truing stand with a simple design and easy to use.

Gauge used for centering adjustment of TS-2 / TS-2.2. Set it on TS-2 / TS-2.2, adjust the center of the arm, and then adjust the caliper arm with the stylus.

A dial gauge that can be attached to the DT-3. The dial gauge quantifies the measurement of slight distortion.

A stand for assembling wheels, checking and adjusting vertical and horizontal runout of rims. Fix the hub core with the bolts on the upper left and right, and adjust the vertical and horizontal runouts while rotating the rim.

Base with tilt function for TS-2 / TS-2.2. The wheel truing stand can be made to stand on its own, and the tilt of the wheel truing stand can be adjusted up to about 20 ° back and forth. Comes with a parts plate and a storage pocket for spoke wrenches (SW-0C-3, SW-40C / 42C).

Extension for TS-2. By attaching the TS-2EXT to the TS-2, you can set the 29-inch wheels on the TS-2 with the tires attached, and you can easily set the through-axle type hub. Compatible with 160mm wide type hubs. It is a quick release type and can be easily installed. * TS-2TA is recommended for... Read More