Extracting Tools

It is used when it becomes necessary to remove the sprue from the tap groove hole. If you turn the sprue counterclockwise while pressing it strongly with the cutting edge of the tool from the top of the inserted sprue, the sprue will wind up and can be removed.

A tool required to remove the insert.

Place the tool at a position 90 ° from the end of the final coil and turn it counterclockwise while pressing it to remove the insert. Dedicated tool for inserting inserts.

It is used when the inserted insert is pulled out from the tap hole.

A tool that breaks off the tongue from the notch after inserting the insert.

It is a repair part for the nail attached to the extraction tool. Replace if worn due to long-term use or if it is accidentally chipped.

It is used when it is necessary to extract the sprue from the female thread of the base material. If you turn the sprue to the left while holding down the inserted sprue with the tip of your sword, the sprue will wind up. *Please note that if the sprue is forcibly pulled out with pliers, etc., th... Read More

You can pull it out with the same feeling as an insertion tool. The conventional type had a fixed handle, but you can easily remove the helisert by grasping the body in the same way as an insertion tool and turning the handle to the left with the other hand.

It is used when it is necessary to extract the sprue from the female thread of the base material. If you turn the sprue to the left while holding down the inserted sprue with the tip of your sword, the sprue will wind up. *Please note that if the sprue is forcibly pulled out with pliers, etc., th... Read More

It is used when it is necessary to extract the sprue from the female thread of the base material. If you turn the sprue to the left while holding down the inserted sprue with the tip of your sword, the sprue will wind up. *Please note that if the sprue is forcibly pulled out with pliers, etc., th... Read More

This is a special tool required to remove the Advanex tongueless insert. For manual extraction, prepare a handle that supports hexagonal bits separately.

If you hit the tip of the tool against the tongue and hit the head of the tool with a hammer, it will break at the notch, and the strong magnet at the tip of the tool will make it easy to remove the tongue. Used to break off the tongue after inserting the sprue.

Place the tool at a position 90 ° from the end of the final coil and turn it counterclockwise while pressing it to remove the insert. Dedicated tool for inserting inserts.

It is a tool that can be pulled out by strongly pressing the cutting edge against the inserted sprue and rotating it counterclockwise. It can be removed without damaging the tap groove. Used to pull out a sprue insert that has already been inserted.