Manual Rebar Cutters & Benders

The cutting edge is angled, and the iron wire protruding from the floor wall etc. is cut without leaving it from the root. The material of the blade and everything else is the reliable sharpness of the bolt clipper. Type: Cutter

The M bar (CW19 / CS19) can be disconnected in one shot. The head rotates 360 degrees, and when cutting near a wall, the handle can cut without hitting the wall. The handle load is light and the cut surface is beautiful. Recommended in places where dust, noise, and sparks cannot be generated, suc... Read More

Safe and secure cutting work anywhere without the need for a power supply. No cutting deformation. It can be used as it is without any post-processing. For perforated angles. Since there is no deformation or burr on the cut surface, it can be used as it is after cutting. It is a manual type that ... Read More

The angle set is quick and the cutting position is clear at a glance. Excellent workability !! Easy !! No power supply required. There are no sparks or chips. Lightweight and easy to carry. Easy cutting with a powerful boosting mechanism.

SUS (stainless steel) runs out !! Manual one-shot disconnection No power supply required, no sparks or chips! Deburring is unnecessary with a beautiful cut surface! You can cut quickly and work efficiency is improved! Compatible with many types of rails by exchanging blades !! D Stainless DP1 for... Read More

The angle set is quick and the cutting position is clear at a glance. Excellent workability !! Easy !! No power supply required. There are no sparks or chips. Lightweight and easy to carry. Easy cutting with a powerful boosting mechanism. Spare blade

SUS (stainless steel) runs out !! D2 expires !! Manual one-shot disconnection No power supply required, no sparks or chips! Deburring is unnecessary with a beautiful cut surface! You can cut quickly and work efficiency is improved! Compatible with many types of rails by exchanging blades !! D2 du... Read More

Safe and secure cutting work anywhere without the need for a power supply. No cutting deformation. It can be used as it is without any post-processing. For changing steel angles. Since there is no deformation or burr on the cut surface, it can be used as it is after cutting. It is a manual type t... Read More

A spare blade for angle cutting machines and perforated angles. * The blade is a consumable item. If the blade becomes dull due to damage or wear, replace the blade. * Because each spare blade is a dedicated blade, please be careful not to make a mistake. * Cutting work with blades of different t... Read More

SUS (stainless steel) runs out !! D2 expires !! Manual one-shot disconnection No power supply required, no sparks or chips! Deburring is unnecessary with a beautiful cut surface! You can cut quickly and work efficiency is improved! Compatible with many types of rails by exchanging blades !! Spare... Read More

D2 and DP2 can be disconnected. No power supply required, one shot disconnection. It is safe because it does not generate chips or sparks. The beautiful cut surface eliminates the need for deburring. It can be cut quickly and work efficiency is improved. Raceway duct D1 type iron / stainless stee... Read More

SUS (stainless steel) runs out !! D2 expires !! Manual one-shot disconnection No power supply required, no sparks or chips! Deburring is unnecessary with a beautiful cut surface! You can cut quickly and work efficiency is improved! Compatible with many types of rails by exchanging blades !! Spare... Read More

Since the conventional angle cutter is exclusively for L type, it was a step further to cut R type angle ... With this, the cut surface can be cut in one shot. For R type angle only

SUS (stainless steel) runs out !! D2 expires !! Manual one-shot disconnection No power supply required, no sparks or chips! Deburring is unnecessary with a beautiful cut surface! You can cut quickly and work efficiency is improved! Compatible with many types of rails by exchanging blades !! Spare... Read More