The reviews are automatic translation.
Floor-mount gas cock lid screw
On 2020-02-18 14:57:51
The kitchen veneer has become fluffy due to the aging of about 40 years,
As the cheapest renovation plan, we decided to re-paint the veneer from above.
(Because the glue between the decorative veneer and the veneer directly is poor, paste a thick veneer (9 mm?) Between them and then apply a new veneer)
As a result, the overall floor thickness increased, and the floor-mounted gas cock lid, which was used to place the stove on the dining table, lifted, and the original screws were no longer enough.
A 50mm M4 screw was sold at a home improvement store, so I thought it would work, but the M4 was too thick to fit.
Inspection revealed that there was an M3 50mm screw, I ordered it with MonotaRO, and it was installed successfully.
Only 50mm is available up to M3, and less than M2 is only about 20mm.
In other words, the smallest diameter is the 50 mm screw of this M3.
This is a thing that is not sold even in a large home improvement store, so it was sold at MonotaRO and it was very helpful.
If you can't get in with the M3 50mm, you'll feel like you're giving up and you'll be able to get through the harrigane. There is no smaller 50mm screw.
Product parts installation
On 2020-01-06 14:49:44
Good without problems
I am very satisfied with the e-mail guidance after ordering.
Door handle replacement repair
On 2019-12-14 16:15:27
Stainless steel pan head M6 × 65mm, length was special, but it was available and saved.
Fix clamp clamp of shaking incubator
On 2019-07-30 14:28:49
I purchased it as a clamp clamp screw for Taitec's shaking culture machine. We could use without problem.
As a component of magnet base of solar panel
On 2019-07-08 15:01:10
As a component of the solar panel magnet base,
Made of stainless steel that is resistant to rust.
Because the magnet side is dish-shaped, this screw is perfect!
On 2019-05-20 08:44:51
There are many cases where the door closeer's cap screw is naturally lost because the lodgings are for more than 20 years, and confirmation is made when leaving the house. The size is just right, well stopped and very good.
On 2019-04-27 19:41:39
There was only cheap It could be broken and the screw was broken and it could not be used. It may be good if the other party is really thin material.
Used to manufacture a jig for bending test
On 2019-03-05 14:41:51
I could wear it without any problem
The grip length is just as well satisfied.
I purchased the disk brake exchange screw substitute of Honda car.
On 2019-02-16 19:13:21
This product is stainless steel and does not rust.
The quantity is also much cheaper than similar products. As expected Osaka Soul brand.
The disc rotors of Honda cars are used in two places with screws of this size.
One genuine screw is 30 yen. Moreover, it is made of iron and rusts straight.
If so, it is definitely better to use this screw, which is cheap, has a large number, and does not rust with stainless steel. Those who replace the disc rotors of Honda cars are strongly recommended to purchase.
On 2019-02-08 10:52:34
When installing the concho, it may be necessary to use a small screw on the flat head.
I like it because the feel around the screw is smooth.
Sometimes it is necessary to have a large plate head, so I am happy that the large plate head is also abundant in size.