S1DX Timer

It was exchange from the old type, but was usable without a problem in particular.

Since the former was made by Panasonic 27 years ago, it was hard to set up because it was a volume scale rather than a number, but it was replaced in 1 minute. In the trial run of the machine, the first start was surprised at the feed motor being jerky!

12V inverter starts up even though the 12V storage battery is not fully recovered. Use this on-delay to give recovery time of about 10 minutes. I am satisfied because I have achieved the required purpose.

Used to thermally weld plastic bags etc using electric wire. Because it was a type with no timer attached, I adopted ESWAN. Even if you do not produce DC 5 V with an AC adapter, we are adopting it to various AC 100 V devices because it keeps accurate time. I am also using it for my own photosensitive substrate exposure machine.

When my car enters the night garage, the lights are automatically turned on, but it is used to set the time until the lights are turned off automatically. I am working everyday, but it is stable. Time is also accurate.

It was very helpful to purchase the same thing as the failed timer. I think that the price is also profitable.

Since it was using the old model number National, if you can post without any problems, you can save the old part number at the same time

Although I was using the ADX 1195, the notation color of the operation LED, which is related to the operation failure and was involved, was different from the previous one

It is a timer relay that is readily available and easy to use. I would like you to post the fact that you need separate leaf springs to the DIN terminal block.

I am pretty precise and satisfied.