The reviews are automatic translation.
Equipment installation work
On 2018-07-19 04:59:58
Although it was used for tightening M12 stainless steel bolt, it was considerably cheaper than dealing with tightening torque and more than purchasing at a nearby home center.
Car repair and replacement
On 2018-07-16 20:22:47
The price is also cheap and easy to use. Next time will also be purchased.
Suitcase wheel repair
On 2018-07-13 00:53:13
The quantity so far was unnecessary. I could narrow down the quantity a little more.
Assembly parts of prototype
On 2018-07-06 13:26:15
I asked today and arrived tomorrow, I was saved, as the shortening of the development period was being screamed.
For shovel head genuine F brake switch spacer (motorcycle).
On 2018-07-05 22:26:58
There is a spacer in genuine, but there is no lineup in the after parts. When it is genuine, it is a flat washer of a special size of a few thousand yen with a spacer (nearly flat washer) single item of approximately 10 mm in outer shape, so that its price is close to none. However, if there is no sole, the F brake switch in question suffers extremely shortening of the service life and causes breakdowns. So this size is grateful.
On 2018-06-29 15:27:59
It is helpful to subdivide it into appropriate quantity. Quality is also no problem.
On 2018-06-27 05:19:32
Used for adjusting the left and right heights of the mirror. I do not have a problem in particular, I think that it is good to rust so it is made of stainless steel.
Support of cylinder carrier
On 2018-06-22 07:46:32
I was surprised that there was a thick washer with a size that was not large.
I use it like seven thick papers like a thick pipe.
To put a hand-made shelf board on the bottom of the wire rack (Lumix)
On 2018-06-09 10:40:20
Tightened while adjusting the height with both the nut on the 10 M bolt of the lower adjuster of the shaft. Because a tapered sleeve can not be used for a hand-made shelf board (welded with steel pipe and angle), it can not be fixed in the middle of the shaft, but this method can be used if it is the bottom. The size was satisfactory. I think that it will withstand the load.
Improvement of car
On 2018-06-07 16:25:22
Used for holding the stabilizer bush. It is rich in size and good. It is not sold at the home center.